Grass Valley 2040RDA-16FR - Manual (Page 21)

2040RDA-FR/16FR — Instruction Manual 21
Installation
2040RDA-FR or 2040RDA-16FR with Optical Transceiver
With the Optical Transceiver SFP option installed the module supports the
following modes:
• Electrical input to eight or sixteen electrical outputs and two optical
outputs, or
• Optical input to eight or sixteen electrical outputs and one optical
output.
Electrical or Optical Input
To use the electrical input, connect an SD, HD, or ASI video input to BNC
J10 on the 2040RDA-FR or BNC J17 on the 2040RDA-16FR as described in
Electrical Input on page 19 . Set on-board jumper JP3 to the Coax input as
described in Input/Output Select Jumpers on page 12 .
For an optical input, connect the fiber cable to the Optic 2 input (right), as
shown in
Figure 15 . Set on-board jumper JP3 to enable the optic input as
described in Input/Output Select Jumpers on page 12 .
Electrical and Optical Outputs
The input signal is distributed to eight or sixteen electrical output BNCs.
Connect video output devices to outputs J1 and J3 through J9 provided on
the 2040RDA-FR rear module (
Figure 12 on page 18 ) or J1 through J8 and
J9 through J16 provided on the 2040RDA-16FR rear module ( Figure 13 on
page 18 ).
The output signal can also be accessed from the Optic 1 (left) connector
shown in
Figure 15 . Enable or disable this output with on-board jumper JP2
as described in Input/Output Select Jumpers on page 12 . With the submodule
handle in the up position, connect an optical cable to this output.
Figure 15. Dual Transceiver Optical Input and Output
8269_14
Optic 1 (output) Optic 2 (input)