Grass Valley 2040RDA-16FR - Manual (Page 20)

20 2040RDA-FR/16FR — Instruction Manual
Installation
2040RDA-FR or 2040RDA-16FR with Dual Optical Transmitter
With the Dual Optical Transmitter installed the module can operate in the
following modes:
• Electrical input to eight electrical outputs and two optical outputs on
the 2040RDA-FR, or
• Electrical input to sixteen electrical outputs and two optical outputs on
the 2040RDA-16FR.
Electrical Input
Connect an SD, HD, or ASI video input to BNC J10 on 2040RDA-FR or BNC
J17 on 2040RDA-16FR as described in
Electrical Input on page 19 .
Electrical and Optical Outputs
The input signal is distributed to eight or sixteen electrical output BNCs.
Connect video output devices to outputs J1 and J3 through J9 provided on
the 2040RDA-FR (
Figure 12 on page 18 ) or J1 through J8 and J9 through J16
provided on the 2040RDA-16FR rear module ( Figure 13 on page 18 ).
The output signal can also be accessed from both optical outputs from the
SFP submodule, Optic 1 (left) and Optic 2 (right), shown in
Figure 14 . Set
on-board jumpers JP2 and JP3 to enable or disable one or both of the optical
outputs as described in
Input/Output Select Jumpers on page 12 . With the
submodule handle in the up position, connect optical cables to one or both
outputs.
Figure 14. Dual Transmitter Optical Outputs
8269_13
Optic 1 (output) Optic 2 (output)