H3C Technologies H3C SecBlade FW Cards - Manual (Page 3)

2
Configuring the management IP address of the
SecBlade firewall card
In the OAA system, a device and an OAP card integrate together and function as one device. For the
snmp UDP Domain-based network management station (NMS), however, a device and an OAP card are
independent SNMP agents. Physically, two agents are on the same managed object; while logically,
they belong to two different systems, and they manage their own MIB objects on the device and the card
separately. Therefore, when you use the NMS to manage the device and the OAP card on the same
interface, you must first obtain the management IP addresses of the two SNMP agents and obtain the link
relationship between them, and then you can access the two agents. By default, the management IP
address of an OAP card is not configured.
Follow these steps to configure the management IP address of an OAP card:
To do… Use the command… Remarks
Enter system view system-view —
Configure the management IP address
of the SecBlade firewall card
(S9500E/S12500 in standalone
mode)
oap management-ip ip-address slot
slot-number Required
Not configured by default.
Configure the management IP address
of the SecBlade firewall card
(S9500E/S12500 in IRF mode) oap management-ip ip-address
chassis chassis-number slot
slot-number
Required
Not configured by default.
CAUTION:
Before the above configuration, you are recommended to configure the same IP address at the OAP card
side; otherwise, the NMS cannot access the OAP card by using the configured management IP address.
Resetting the operating system of the SecBlade
firewall card
If the operating system works abnormally or is under other anomalies, you can reset the system of a
SecBlade firewall card with the following command, which equals to resetting the firewall card by
pressing the reset button on the firewall card.
A firewall card has its independent CPU; therefore, the device can still recognize and control the firewall
card after you reset the system. That is, restart of the firewall card does not result in the restart of the
device.
Follow these steps to reset the system of the SecBlade firewall card:
To do… Use the command… Remarks
Reset the system of a SecBlade firewall
card (SR6600/SR8800, or
S7500E/S9500E/S12500 in
standalone mode)
oap reboot slot slot-number
Required
Available in user view
Reset the system of a SecBlade firewall
card (S5800) oap reboot slot slot-number
system system-name Required
Available in user view