Oap management-ip – H3C Technologies H3C SecBlade FW Cards User Manual
Page 11
2
Press CTRL+K to quit.
Connected to OAP!
oap management-ip
Syntax
S9500E/S12500 in standalone mode:
oap management-ip ip-address slot slot-number
undo oap management-ip slot slot-number
S9500E/S12500 in IRF mode:
oap management-ip ip-address chassis chassis-number slot slot-number
undo oap management-ip chassis chassis-number slot slot-number
View
System view
Default Level
2: System level
Parameters
slot slot-number: Number of the slot where an OAP card resides.
ip-address: Management IP address of the OAP card. This address must be configured on the OAP card
beforehand.
chassis chassis-number slot slot-number: Number of the slot and ID of the member device where an OAP
card resides
Description
Use the oap management-ip command to configure the management IP address of an OAP card.
Use the undo oap management-ip command to restore the default.
By default, the management IP address of an OAP card is not configured.
When you use network management station (NMS) to manage an OAP card, you must first configure the
management IP address of the OAP card.
Examples
# Configure the management IP address of the OAP card in slot 3 as 1.1.1.1. (S9500E/S12500 in
standalone mode)
[Sysname] oap management-ip 1.1.1.1 slot 3
# Configure the management IP address of the OAP card in slot 5 on member device 2 as 1.1.1.1.
(S9500E/S12500 in IRF mode)
[Sysname] oap management-ip 1.1.1.1 chassis 2 slot 5