H3C Technologies H3C SecBlade FW Cards - Manual (Page 20)

11
View
Interface view
Default Level
2: System level
Parameters
None
Description
Use the acsei-client enable command to enable ACSEI client.
Use the undo acsei-client enable command to disable ACSEI client.
By default, ACSEI client is disabled.
Examples
# Enable ACSEI client on interface Ten-GigabitEthernet 0/0.
system-view
[Sysname] interface ten-gigabitEthernet 0/0
[Sysname-Ten-GigabitEthernet0/0] acsei-client enable
display acsei-client information
Syntax
display acsei-client information
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display acsei-client information command to display information about ACSEI client.
Examples
# Display information about the current ACSEI client.
display acsei-client information
Client Description: SecBlade II
Hardware: A.0
System Software: COMWAREV500R002B38D001
Application Software: V300R001B01D006
CPU: RMI XLR732 1000MHz
PCB Version: A.0
CPLD Version: 1.0
Bootrom Version: Basic BootRom Version:1.02,Extend BootRom Version:1.01
CF card: 256M Bytes Compact Flash Storage Device
Memory: 1024M Bytes DDR2 SDRAM Memory