Oap reboot – H3C Technologies H3C SecBlade FW Cards User Manual
Page 12
3
oap reboot
Syntax
SR6600/SR8800, or S7500E/S9500E/S12500 in standalone mode:
oap reboot slot slot-number
S5800:
oap reboot slot slot-number system system-name
S7500E/S9500E/S12500 in IRF mode:
oap reboot chassis chassis-number slot slot-number
View
User view
Default Level
2: System level
Parameters
slot slot-number: Specifies the OAP card residing in a slot. (SR6600/SR8800, or
S7500E/S9500E/S12500 in standalone mode)
slot slot-number system system-name: Specifies the OAP card residing in a slot on an IRF member device.
(S5800)
chassis chassis-number slot slot-number: Specifies the OAP card residing in a slot on an IRF member
device. (S7500E/S9500E/S12500 in IRF mode)
Description
Use the oap reboot command to reset the system of an OAP card.
Examples
# Reset the system of the OAP card in slot 3. (SR6600/SR8800, or S7500E/S9500E/S12500 in
standalone mode)
This command will recover the OAP from shutdown or other failed state.
Warning: This command may lose the data on the hard disk if the OAP is not being shut down!
Continue? [Y/N]:y
Reboot OAP by command.
# Reset the system of the OAP card in slot 3 on member device 1. (S5800)
This command will recover the SubSlot3 from shutdown or other failed state.
Warning: This command may lose the data on the hard disk if the SubSlot3 is not
being shut down! Continue? [Y/N]:y
Reboot SubSlot3 by command.
# Reset the system of the OAP card in slot 5 on member device 2. (S7500E/S9500E/S12500 in IRF
mode)
This command will recover the OAP from shutdown or other failed state.
Warning: This command may lose the data on the hard disk if the OAP is not being shut down!
Continue? [Y/N]:y