H3C Technologies H3C SecPath F5000-S Firewall - Manual (Page 38)

29
Checking after power-on
After powering on the firewall, verify that:
• The LEDs on the front panel are normal. For more information about LEDs, see "MPU LEDs."
• The fans are operating properly, and you can hear fan rotating.
• The configuration terminal displays information normally. You can see the startup window on the
local configuration terminal.
• After the POST, the system prompts you to press Enter. When the command line prompt appears,
the firewall is ready to configure.
Displaying boot information
Power on the firewall, and you can see the following information:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Press Ctrl+T to start heavy memory test
Booting Normal Extend BootWare........
The Extend BootWare is self-decompressing.....Done!
****************************************************************************
* *
* H3C SecPath Series BootWare, Version 1.18 *
* *
****************************************************************************
Compiled Date : Jul 8 2013
CPU Type : XXX
CPU Clock Speed : 1400MHz
Memory Type : DDR3 SDRAM
Memory Size : 4096MB
Memory Speed : 1333MHz
BootWare Size : 768KB
Flash Size : 8MB
cfa0 Size : 247MB
CPLD_A Version : 1.0
CPLD_B Version : 1.0
PCB Version : Ver.A
BootWare Validating...
Backup Extend BootWare is newer than Normal Extend BootWare,Update? [Y/N]
Press Ctrl+B to enter extended boot menu...
Press Ctrl + B at the prompt within four seconds to access the Boot menu. Otherwise, the system enters the
system image file reading and self-compressing process.