H3C Technologies H3C S3100V2 Series Switches - Manual (Page 75)

67
Configuring aging timers for dynamic ports globally
Follow these steps to configure aging timers for dynamic ports globally:
To do... Use the command... Remarks
Enter system view system-view —
Enter MLD snooping view mld-snooping —
Configure dynamic router port
aging time
router-aging-time interval
Optional
260 seconds by default
Configure dynamic member port
aging time
host-aging-time interval
Optional
260 seconds by default
Configuring aging timers for dynamic ports in a VLAN
Follow these steps to configure aging timers for dynamic ports in a VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id —
Configure dynamic router port
aging time mld-snooping router-aging-time
interval Optional
260 seconds by default
Configure dynamic member port
aging time mld-snooping host-aging-time
interval Optional
260 seconds by default
Configuring static ports
If all the hosts attached to a port is interested in the IPv6 multicast data addressed to a particular IPv6
multicast group, configure that port as a static member port for that IPv6 multicast group.
You can configure a port of a switch to be a static router port, through which the switch can forward all
IPv6 multicast data it received.
Follow these steps to configure static ports:
To do... Use the command... Remarks
Enter system view system-view —
interface interface-type
interface-number
Enter Ethernet interface/Layer 2
aggregate interface view or port
group view
port-group manual
port-group-name
Required
Use either approach
Configure the port(s) as static
member port(s)
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
Required
No static member ports by default
Configure the port(s) as static
router port(s) mld-snooping static-router-port
vlan vlan-id Required
No static router ports by default