H3C Technologies H3C S3100V2 Series Switches - Manual (Page 23)

17
Figure 21 Mounting bracket for wall mounting
1 2
3
(1) Screw hole (M6 expansion anchor is recommended) for fixing the mounting bracket to the wall
(2) Screw hole (M4 screw) for fixing the mounting bracket to the switch
(3) M4 screws for fixing the mounting bracket to the switch
To mount the switch to a wall, H3C recommends you to use M6 expansion anchors. An expansion
anchor comprises anchor rod, anchor sleeve, flat washer, spring washer, and hex nut.
Figure 22 Expansion anchor
1 2 3 4 5
6
(1) Anchor rod (2) Hex nut
(3) Flat washer (4) Anchor sleeve
(5) Cone end (6) Spring washer
Magnet kit
A magnet kit comprises a magnet and an M3*6 countersunk head screw, as shown in Figure 23 . When
magnet-mounting the switch, you must use four magnet kits.
Figure 23 Magnet kit
1
2
(1) Magnet (2) M3*6 countersunk head screw for fixing the magnet to the switch