H3C Technologies H3C S7500E Series Switches - Manual (Page 30)

20
Figure 14 Installing an air filter (S7503E)
Mounting the switch in the rack
CAUTION:
•
Do not hold the handle of the fan tray, power module, or the back cover of the chassis, or the air vents
of chassis to move the switch. Any attempt to carry the switch with these parts might cause equipment
damage or even bodily injury.
• Use a mechanical lift for switches of a high weight.
• After placing the switch on the slide rails, do not leave go of your hands immediately because this might
tip and damage the switch, and even cause bodily injury.
To mount the switch in the rack:
1. Face the rear of the chassis towards the front of the rack.
2. Use a minimum of two people to lift the switch until the bottom of the switch is a little higher than
the slide rails on the rack.
3. Place the switch on the slide rails and slide the switch along the slide rails until the mounting
brackets on the switch touch the front rack posts.
4. Secure the chassis to the rack with mounting screws.