H3C Technologies H3C S7500E Series Switches - Manual (Page 27)

17
• Other models—Install the cable management brackets to the mounting brackets, and then install
the mounting brackets to the chassis. For more information, see " Installing the cable management
brackets on other models " and " Installing the mounting brackets ."
Installing the cable management brackets on the S7506E-V
The S7506E-V has two cable management brackets: the one with a tray is installed at the lower part of
the switch, and the one without a tray is installed at the upper part of the switch. They are installed in the
same way.
To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the screw holes in
the chassis, as shown in
Figure 10 .
3. Fasten the screws.
Figure 10 Installing cable management brackets on an S7506E-V
Installing the cable management brackets on other models
For the models except the S7506E-V, install the cable management bracket on the left mounting bracket,
as shown in Figure 11 . The switch is supplied with two mounting brackets, and the one with the cable
management bracket screw holes is the left mounting bracket.