H3C Technologies H3C S12500-X Series Switches - Manual (Page 80)

73
# Verify that VM 1, VM 2, and VLAN-interface 20 (20.1.1.5) on Switch E can ping each other.
(Details not shown.)
Distributed VXLAN IPv4 gateway configuration example
Network requirements
As shown in Figure 18 :
• Configure VXLAN 10 and VXLAN 30 as unicast-mode VXLANs on Switch A, Switch B, and Switch
C to provide connectivity for the VMs across the network sites.
• Manually establish VXLAN tunnels and assign the tunnels to the VXLANs.
• Configure distributed VXLAN IP gateways on Switch A and Switch C to forward traffic between
VXLAN 10 and VXLAN 30.
• Configure Switch B as a border gateway to forward traffic between the VXLANs and the WAN
connected to Switch E.
Figure 18 Network diagram
Configuration procedure
1. Configure IP addresses and unicast routing settings:
# Assign IP addresses to interfaces, as shown in
Figure 18 . (Details not shown.)
# Configure OSPF on all transport network switches (Switches A through D). (Details not shown.)
# Configure OSPF to advertise routes to networks 10.1.1.0/24, 20.1.1.0/24, and 25.1.1.0/24
on Switch B and Switch E. (Details not shown.)
2. Configure Switch A:
# Enable L2VPN.
system-view
[SwitchA] l2vpn enable