H3C Technologies H3C S12500-X Series Switches - Manual (Page 57)

50
Display VXLAN IS-IS information for
tunnel interfaces.
display vxlan isis tunnel [ tunnel-number ]
Clear data for the VXLAN IS-IS process. reset vxlan isis
VXLAN IS-IS configuration example
Network requirements
As shown in Figure 11 :
• Configure unicast-mode VXLANs on Switch A, Switch B, and Switch C to provide Layer 2
connectivity for the VMs across different sites.
• Manually set up VXLAN tunnels between the VTEPs.
• Configure VXLAN IS-IS to advertise MAC reachability information and automate VXLAN tunnel
assignment. Use VXLAN 11111 as the reserved VXLAN for VXLAN IS-IS.
Table 4 shows the VLAN and VXLAN mapping scheme.
Table 4 VXLAN and VLAN mappings
VMs VLAN VXLAN VTEPs
VM 1, VM 5 VLAN 2 VXLAN 10000 Switch A, Switch B
VM 2, VM 6 VLAN 3 VXLAN 10001 Switch A, Switch B
VM 3, VM 7 VLAN 4 VXLAN 10002 Switch A, Switch C
VM 4, VM 8 VLAN 5 VXLAN 10003 Switch A, Switch C
Figure 11 Network diagram
Configuration procedure
1. Configure IP addresses and routing settings: