Verifying the configuration – H3C Technologies H3C S12500-X Series Switches User Manual

Page 36

[SwitchF-Vlan-interface21] quit

[SwitchF] interface vlan-interface 22

[SwitchF-Vlan-interface22] pim sm

[SwitchF-Vlan-interface22] quit

[SwitchF] interface vlan-interface 23

[SwitchF-Vlan-interface23] pim sm

[SwitchF-Vlan-interface23] quit

Configure Switch G:
# Enable IP multicast routing.

system-view

[SwitchG] multicast routing

[SwitchG-mrib] quit

# Enable IGMP and PIM-SM on VLAN-interface 12.

[SwitchG] interface vlan-interface 12

[SwitchG-Vlan-interface12] igmp enable

[SwitchG-Vlan-interface12] pim sm

[SwitchG-Vlan-interface12] quit

# Enable PIM-SM on VLAN-interface 22.

[SwitchG] interface vlan-interface 22

[SwitchG-Vlan-interface22] pim sm

[SwitchG-Vlan-interface22] quit

Verifying the configuration

Verify the VXLAN settings on the VTEPs. This example uses Switch A.
# Verify that the VXLAN tunnel interfaces on the VTEP are up.

[SwitchA] display interface tunnel 1

Tunnel1

Current state: UP

Line protocol state: UP

Description: Tunnel1 Interface

Bandwidth: 64 kbps

Maximum transmission unit: 64000

Internet protocol processing: Disabled

Last clearing of counters: Never

Tunnel source 11.1.1.1, destination 12.1.1.2

Tunnel protocol/transport UDP_VXLAN/IP

# Verify that the VXLAN tunnels have been assigned to the VXLAN.

[SwitchA] display l2vpn vsi verbose

VSI Name: vpna

VSI Index : 0

VSI State : Up

MTU : 1500

Bandwidth : -

Broadcast Restrain : -

Multicast Restrain : -

Unknown Unicast Restrain: -

MAC Learning : Enabled

This manual is related to the following products: