beautypg.com

Installation, 7400-gps option field installation procedure, 7400-gps option kit – Ensemble Designs 9400 3G Test Signal and Sync Pulse Generator User Manual

Page 17: Installation 17

background image

www.ensembledesigns.com

Avenue 7400 and 9400 - Page 17

Model 7400 HD/SD and Model 9400 3G/HD/SD Sync Pulse Generator and Test Signal Generator

Installation

Plug the 7400 or 9400 module into any one of the slots in the 3RU frame. In a 1RU frame, 7400 and

9400 modules can be installed in slots 1 or 2, and not in slot 3. Install the plastic overlay provided

onto the corresponding group of rear BNC connectors associated with the module location. Note that

the plastic overlay has an optional adhesive backing for securing it to the frame. Use of the adhesive

backing is only necessary if you would like the location to be permanent and is not recommended

if you need to change module locations. This module may be hot-swapped (inserted or removed)

without powering down or disturbing performance of the other modules in the system.

7400-GPS Option Field Installation Procedure

The 7400-GPS Option seamlessly integrates into the Avenue system by plugging directly onto a 7400

or 9400 module. It can be easily installed in the field. The 7400-GPS Option consists of a compact,

weatherproof antenna (with internal high-gain pre-amp) and a receiver submodule which mounts

directly to the 7400 or 9400 module. The included GPS antenna mounts onto standard 3/4” threaded

pipe, metal or plastic. Connection from the F-style coaxial fitting on the antenna to the appropriate

BNC on the Avenue Frame can be made with customer supplied standard 75 ohm cable. The coax

cable can be routed through the center of the pipe for a completely waterproof installation. When low

loss cable such as Belden 1694A is used, the antenna can be placed up to 200 feet (60 meters) from the

frame. Ideally, the antenna is mounted outdoors where it has an unobstructed view of the sky.

If you order the 7400-GPS Option and Model 7400 or 9400 at the same time, we will install the

7400-GPS Option on to the main module at the factory. If you order the 7400-GPS Option and already

have Model 7400 or 9400, you will receive the following kit.

7400-GPS Option Kit

The 7400-GPS Option consists of the following components, see photograph below:

• GPS Option submodule

• Power and Control cable

• Three coaxial jumper cables

• Four Phillips machine screws

• GPS Compact Weatherproof Antenna with internal high-gain pre-amp (not shown in photo)

This manual is related to the following products: