Ensemble Designs 8500 Composite / SD Legalizer and Video Processing Frame Sync User Manual
Page 42
The Filter menu shown below allows setting of the luminance and chroma sharpness
(with DNR option) with the following detail enhancing controls:
•
Lum Sharp – set to Off to bypass detail enhancing filters. Set to 1/4, 1/2, or Max
to set the sharpness of the luminance portion of the signal.
•
Chr Sharp – set to Off to bypass detail enhancing filters. Set to 1/2, 1/4, or Max
to set the sharpness of the chrominance portion of the signal.
Use the Timing menu shown below to adjust the following parameters:
•
Fine Phase – adjust for proper ScH phase with respect to other sources. If fine
phase will not adjust properly, readjust the horizontal phase by up to ± 2 clocks
until the fine phase falls into place.
•
Hor Timing – adjust the horizontal timing of the output signal to place the
leading edge of sync coincident with other sources.
•
Vertical Timing – set the vertical timing to a typical setting of 0 lines.
This menu provides a Delay window at the bottom of the screen that will report the total
delay in lines of the module.
Model 8500 Series Modules
8500-42