Ensemble Designs 8500 Composite / SD Legalizer and Video Processing Frame Sync - Manual (Page 11)

CABLING
Refer to the 3 RU and 1 RU Backplane with 8410 and 8510 Audio Submodule or
3 RU and 1 RU Backplane with 8415 Audio Submodule diagrams on the following
pages for cabling instructions. Note that unless stated otherwise, the 1 RU cabling expla-
nations are identical to those given in the 3 RU diagram.
Configure the three BNCs as described above and follow the correct cabling procedures
depending on how these switches have been configured.
8410, 8415 or
8510 Audio Processor
8520 DNR
CPST
SDI
Set toggle switches to configure BNCs on the rear module.
S4 and S5 will depend on the type of audio processor submodule installed.
S1 (Cpst/SDI)
S4 (8410/8510 — AES 1/2 or SDI) or (8415 — AES 5/6 or SDI)
S5 (8410/8510 — AES 3/4 or SDI) or (8415 — AES 7/8 or SDI)
Match arrows on submodule
and circuit board.
S1
AES
SDI
S4
AES
SDI
S5
Submodule Installation and BNC Configuration Switches
Model 8500 Series Modules
8500-11