Ensemble Designs 8500 Composite / SD Legalizer and Video Processing Frame Sync User Manual
Page 35
Use the Aud In menu shown below for the 8410 and 8510 to adjust the following parame-
ters:
•
1/2 Input – select the input audio source for Input 1/2.
•
3/4 Input – select the input audio source for Input 3/4.
•
1/2 Mode – for a Serial input with embedded audio, select the type of audio in the
stream:
•
Audio – the embedded stream is standard audio.
•
Data – the embedded stream is a non-audio signal.
•
Auto – the module will detect the type of signal embedded in the stream,
audio or data.
•
3/4 Mode – select the type of audio in the serial stream as described above.
•
DeMux Group – select the embedded audio group to demultiplex from the selec-
tions. The status of embedded audio is shown in the Embed In view.
•
Anlg In Lvl (8510 only)– set the nominal level of the analog audio input.
Setting analog levels: For example, if the nominal level of your incoming analog audio is
+4 dB, set the Anlg In Lvl to +4 dB (8510 only).
The status of the corresponding audio inputs are shown next to the control. Status is
reported as one of the following:
•
Analog In (8510 only) – analog video is present on the input.
•
No Input – no serial digital embedded audio is detected.
•
Audio Sync – the audio embedded in the stream is synchronous with the timing
reference.
•
Data Sync – the data embedded in the stream is synchronous with the timing
reference.
•
Audio Async – the audio embedded in the stream is non-synchronous with the
timing reference.
Model 8500 Series Modules
8500-35