ARM Electronics RDVR16A - Manual (Page 24)

1) TITLE:
Show the title of each channel of the camera.
2) DET:
Select “ON” to activate the motion detect function of each channel.
Select “OFF” to inactivate the motion detect function of each channel.
3) AREA:
Press the “ENTER” button to set detection area.
In this function, the default setting is un-detecting any area. Pink blocks
represent the area that is not being detected. While the transparent blocks is
the area that is under detection.
: navigates between targets.
4) LS :
The sensitivity of comparing two different images. The smaller the value
is, the higher sensitivity for motion detection.
The highest sensitivity setting is 00, the lowest sensitivity setting is 15.
The default value is 07.
5) SS :
The sensitivity towards the size of the triggered object on the screen.(the
number of motion detection grids). The smaller the value is, the higher
sensitivity for motion detection.
The highest sensitivity setting is 00, and the lowest sensitivity setting is
15. The default setting is 03.
Note: The default setting of Spatial Sensitivity is 03, which means when 3 grids
are detected for motion at one time, the system will get triggered. So the
value of Spatial Sensitivity must be less than the number of grids which
you set up to motion detection area.
▲
▲
▲
▲
Press “ENTER” to confirm
the start area
Press or to choose
the width of the area
Press ▲ or ▼ to choose
the height of the area,
and press “ENTER”
again to confirm.
You can have multi-
detected area Press “－” to turn all
area under detection Press “＋” to turn all
area not to be detected
▲
▲
20