Aqua Lung WTX-D Buoyancy System User Manual

Page 27

Table of Contents

GripLock

Patch

1. Set the buoyancy cell on a flat surface with the zipper side face up. Remove the bail from the

cylinder band. Insert the GripLock™ band through the upper right oval grommet hole with the

GripLock™ patch facing up.

2. Identify the two upper and lower vertical slots in the

center of the WTX backplate at the top and bottom.

3. Turn the buoyancy cell over and place the WTX

backplate on top with the Apeks logo face up. Insert

the cylinder band into slot 1, bring it around the plate

and out slot 2. After exiting slot 2, direct the cylinder

band out the upper left oval grommet hole on the

buoyancy cell. Make sure the cylinder band passes

through both slots in the plate and buoyancy cell

grommet holes.