Aqua Lung WTX-D Buoyancy System User Manual

Page 25

Table of Contents

GripLock

Patch

4. Repeat the process for the lower cylinder band.
See the following section to finish attaching the WTX-D

system to a cylinder:

1. Set the buoyancy cell on a flat surface with the zipper side face up. Remove the bail from the cylinder

band. Insert the GripLock™ band through the upper right oval grommet hole with the GripLock™ patch

facing up.

2. Turn the buoyancy cell over and place the ultralight

plate on top with the Apeks logo face up. Insert the

cylinder band end through the oval grommet hole

in the ultralight plate on the same side. Bring the

cylinder band end around the plate and exit the oval

grommet holes on the upper left side. Make sure

the cylinder band passes through both the ultralight

plate and buoyancy cell grommet holes.

3. Turn the buoyancy cell back over, so the zipper side is

face up.