Amer Networks WAP43DC Fat Web - Manual (Page 6)

6
WAP43DC FAT Web Manual Chapter 1 Introduction
1.5 Introduction to Web Management Function
Listed below are the available functions within the Network Management Interface. Table
1-1:
Basic Settings Show the AP address (IP address and MAC
address), version (firmware version) and device
information. The admin password, serial ports
configuration and system settings can be
configured.
Status Interfaces Show the real-time wired and wireless
configuration of the APs.
Transmit/Receive Show the transmission of packets with the
associated AP.
Client Association Show the current status of the connected APs
Advanced
Configuration
Configure the wireless parameters for the
Access point.
Ethernet Settings Configure the related wired settings of an AP.
This includes Host name, Management VLAN,
Untagged VLAN, DHCP, Static IP and DNS
server.
Wireless Settings Configure the related wireless settings of an AP.
This includes country code, radio interface,
physical mode and channel.
Radio Configure the RF parameters. This includes
radio interface, physical mode, channel, channel
bandwidth, primary channel, supporting short
protection interval or not, STBC mode,
protection, beacon frame interval, DTIM interval,
fragment threshold, RTS threshold, maximum
stations, transmission power.
VAP (Virtual AP) Configure the authentication mode of a virtual
AP and the related configuration.
WDS Configure the WDS settings.
AP Mode Configure the mode and IP address of an AP.
System
Maintenance
Reset the unit, back up the config, update the
firmware.
Configuration Restart an AP. Restore an AP to factory
defaults. Import and export files.
Upgrade Update the firmware of an AP.