Amer Networks WAP43DC Fat Web - Manual (Page 41)

41
WAP43DC FAT Web Manual Chapter 6 Configuration Examples
In a small office, the device administrator can complete the WPA2-PSK wireless
access configuration through the web page. The detailed commands are listed below:
• AP provides the WPA2-PSK wireless access service with SSID as “psk”.
• For meeting the high bandwidth demands of wireless users, select the 802.11n
(2.4GHz) RF mode.
Fig 1-18 WPA2-PSK wireless access
6.3.2 Configuration Steps
1. Login into the AP configuration page and enter into the wireless configuration page.
Choose to enable for RF1.
Choose IEEE 802.11b/g/n for the wireless mode.
Use the default configuration for the channel.
Click “submit” button.
2. Enter into the virtual AP configuration page.
Choose the virtual AP enabled box (the virtual AP 0 is enabled as default.)
Configure the VLAN ID according to the actual situation.
Configure SSID as “psk”.
Use the default configuration for “broadcast SSID”.
Choose “WPA Personal” for the security configuration.
Click to choose WPA2 for the WPA version according to the requirement and cancel
the WPA.
Use the default configuration for the cipher suites.
Configure the Key 1 as 12345678.
Use the default configuration for the broadcast key refresh rate.
Click “submit” button.