Amer Networks WAP43DC Fat Web - Manual (Page 40)

40
WAP43DC FAT Web Manual Chapter 6 Configuration Examples
Choose IEEE 802.11b/g/n for the wireless mode.
Use the default configuration for the channel.
Click “submit” button.
2. Enter into the virtual AP configuration page.
Choose the virtual AP enabled box (the virtual AP 0 is enabled as default.)
Configure the VLAN ID according to the actual situation.
Configure SSID as “WEP”.
Use the default configuration for “broadcast SSID”.
Choose “Static WEP” for the security configuration.
Configure the key index as 1.
Configure the length of key as 64bits.
Configure the key type as ASC II.
Configure the WEP key 1 as 12345.
Configure the authentication method as “open system”
Click “submit” button.
6.2.3 Test the Configuration Results
Enable the wireless client and refresh the network list. Find the configured network
service in the list of “choose wireless network” (it is PSK in this example). Click
“connect” and input the WEP key as 12345 in the dialog box (the input WEP key
must be the same as the configured WEP key on the device). After associated with
the AP successfully, user can access the wireless network.
Enter into the client association page and the successful online clients can be
viewed.
6.3 WPA2-PSK Wireless Access
6.3.1 Networking Requirements