How to do live ptz operation – ACTi INR-410 INR-420 V3.0.09 User Manual

Page 79

INR-410/420 System Administrator’s Manual

Address ID

Address ID represents the identity of the device, only analog devices or speed

dome cameras require this configuration. Please refer to the Address ID of the

device and choose exactly the same baud rate setting also in the NVR server.

Available value is from 1~99. By default, ACTi devices

will use “1” as Address

ID, it is suggested not to change it.

How to Do Live PTZ Operation

To configure PTZ settings, you need to view the live streaming while manipulating the PTZ

controls simultaneously in this window.

There are two kinds of PTZ navigation:

Optical PTZ Navigation

Get the live view from Live Preview window:

Make sure the

“Enable PTZ” is checked, and a red crosshair will appear on the Live

Preview window. If the device is in Dual Stream mode, this window will always shows the

stream set for live view. You may click on to switch between the streams.

Use the mouse to do the following PTZ operations:

To execute optical Panning and Tilting, click anywhere on the live window to allow the

camera to move in that direction. The length of the direction indicator is proportional to the

Pan and Tilt speed. The farther you place the cursor from the center, the faster the

Pan/Tilt movement.

Live Preview

Important Notice

Note that the functions supported for devices connected using ONVIF are live streaming and
adjustments to video image settings.