ACTi INR-410 INR-420 V3.0.09 - Manual (Page 18)

www.acti.com
INR-410/420 System Administrator’s Manual
18
Rackmount the Unit
To make system maintenance easier, you may want to put INR-410/420 into the rack. To
rackmount INR, you will need to install INR Sliding Rail Kit, offered as an optional accessory,
on INR and make sure there is 2U space in your rack. For detailed installation instructions,
please refer to Rackmount Installation Guide packed with the sliding rail kit.
Hard Disk Installation
For video recordings, you should install at least ONE certified 3.5-inch SATA hard disk. Be sure
to use the hard disk models ACTi has tested to be compatible with INR-410/420, and it is
strongly recommended that you use hard disks of the same model and capacity. You may find
the certified models via http://www.acti.com/hddselector .
The actual necessary space depends on the number of devices, recording and event rules
settings. To get an approximate value, you may use ACTi software tool Bandwidth & Storage
Calculator at http://www.acti.com/storagecalculator .
You can install up to 7 disks in to Storage Disk Bays. During the installation, please avoid
removing the System Disk Bay .
Step 1: Remove the Tray

Slide the Key Lock aside, the Latch Lever
will pop out by itself.

Hold the Latch Lever to pull out the tray.