ACTi INR-410 INR-420 V3.0.09 User Manual
Page 61
INR-410/420 System Administrator’s Manual
Brand
Select the manufacturer of device.
Model
Select the device model of the IP cameras / video servers. In most
cases, this is automatically filled in after you perform Get Device
Setting for ACTi cameras.
Stream Mode
*
1
Select one of the streaming modes this device supports.
Channel No.
*
2
The channel ID you set for a stream of a multi-streaming device.
HTTP Port
Enter the HTTP port for IP cameras/ video servers. Most cameras
use the default port number - 80.
User Name
Enter the user name to access the camera.
Password
Enter the password to access the camera.
Default Live View
Stream
*
3
Choose the streaming id for Live View.
Recording Stream
*
3
Choose the streaming id for Recording.
Connection
Timeout(0~99 secs)
Enter length of time allowed for a device to respond to NVR. If the
response is to late as to exceed this time, NVR will consider this
device “disconnected”. We recommend you to set different values for
different types of connection. The default setting is 5 seconds. For
devices located over the WAN, you may wish to increase this value to
allow for occasional Internet lags.
*
1
Available when NVR is connected to a multi-streaming device.
*
2
Available when NVR is connected to a device that is concurrently in multi-streaming mode (Dual
Stream mode excluded).
*
3
Available when NVR is connected to a multi-streaming device in Dual Stream mode
.
Note
Current NVR version does not support ePTZ operation of 6VGA streaming mode. Please
define 6 VGA views through camera web configurator.