Westermo MRD-3x0 - Manual (Page 59)

59 6623-3201
4.2 DHCP Server Configuration
The DHCP server allows clients on the local network to be
automatically allocated IP addresses from the MRD-3xx. The
MRD-3xx will also provide the clients with network settings
like their default route and DNS servers.
By default the DHCP server is disabled however it has been
configured to serve IP addresses in the range 192.168.2.210
through 192.168.2.240, and the Default and Maximum lease
times have been set to 1440 minutes. So if these values are
consitant with the network that the MRD-3xx is connected
to, then the DHCP can be enabled by setting the Enabled field
to Yes and clicking the Update button.
Figure 49: DHCP configuration.
If the standard settings are not applicable for the connected
network, then refer to Figure 49 and follow the steps below,
to configure the DHCP server:
1. Click the Network tab on the main menu, this will display the
LAN page as shown in Figure 49, the DHCP settings are in the
section titled DHCP Server Configuration.