Westermo MRD-3x0 - Manual (Page 178)

178 6623-3201
Only accept data from master IP address
When set, this field will cause the serial server to only accept
data sourced from the address set in the Master address field.
Timeout for TCP connections
For TCP connections only, when this field is set to a value
greater than 0, the serial server will close connections that
have had no receive activity for longer than specified (sec-
onds).
Drop existing TCP connection if new received
For TCP connections only, if a connection is currently active
on the serial server, and a new connection request is accepted,
this field determines the action that will be taken. If set, the
new connection will become the active connection and the
existing connection will be closed. If not set, the existing con-
nection will remain active and the newly received connection
will be closed.
Timeout between failed TCP connects
For TCP dual endpoint only, if a connection request has failed,
the server will wait the amount of time (in seconds) specified
in this field before attempting another connection request.
While a short timeout may cause the connection to be estab-
lished more quickly, it may also cause greater network traffic if
the remote host is unavailable and repeated attempts fail.
Failed TCP connects before giving up
For TCP dual endpoint only, the serial server will attempt
to establish a connection for the number of times specified
in this field be giving up and waiting for a connection to be
accepted.
Destination address for UDP packets
For UDP endpoint only, the serial server can be configured to
behave as follows: