Westermo MRD-3x0 - Manual (Page 58)

58 6623-3201
4.1.2 Disabling the LAN Interface
By default the LAN interface is enabled. The LAN interface
can be disabled if the LAN ports are not required.
Note: If the LAN ports are disabled then access to the web
configuration pages will only be available via the wireless inter-
face if the the Firewall settings allow access to the Web Server,
for details on the Firewall configuration refer to Section 5. To
re-enable the LAN ports without accessing the Web interface,
it will be necessary to perform a factory reset of the MRD-
3xx as described in the User Guide, this will clear all the
configuration settings of the MRD-3xx to the factory default
settings and the LAN ports will be enabled.
To disable the LAN Interface :
1. Click the Network tab on the main menu, this will display the
LAN page as shown in Figure 47 the LAN interface settings are
in the section titled Interface Configuration.
2. Untick Enabled checkbox.
4. Click Ok.
5. Click the Update button at the bottom of the page to com-
mit the changes.
The LAN interface will now be disabled, if the connection to
the MRD-3xx was via the LAN ports, a page error may now
be indicated.