Westermo MRD-3x0 - Manual (Page 12)

12 6623-3201
1.2 Configure the LAN interface and DHCP Server
To access the configuration page for the LAN interface and
DHCP Server, select Network from the top level menu and
LAN from the sub menu. The LAN interface screen similar to
Figure 10 will be shown.
Figure 10: LAN interface configuration.
1.2.1 Setting the IP Address
If it is desired to change the IP address of the LAN port, fol-
low the steps below:
Enter the new IP address and netmask in the •
Interface Configuration table.
Click
• Update to set the changes. Once the changes
have been set, the IP address of the MRD-3xx Unit
will change. Enter the new address in the browser
on the PC. It will be necessary to login again, follow-
ing the procedure described in the previous section.
1.2.2 Enabling DHCP
The DHCP server allows clients on the local network to
be automatically allocated IP addresses from the MRD-310.
The unit will also provide the clients with network settings
like their default route and DNS servers. By default the
DHCP server is disabled but if enabled it will be configured