Welltech WG26xx Series V.1.08a - Manual (Page 87)

26xx Technical Manual EN-V108
86
Example 3
This configuration shows an example for P2P calling to a representative number.
When a PSTN call is coming to 2680 FXO port, it will start the call routing and
make the p2p call to the sip trunk number of 2608 which provides serial line
hunting. The same as 2608 to route to 2680’s sip trunk number.
A. Configuration 2608
Step 1:
Check the primary proxy and sip trunk number enable option, and then setup the
required parameters of the sip trunk number. Apply it.
Since the P2P call will be used for this sip trunk number, uncheck the primary
proxy and apply it.