Welltech WG26xx Series V.1.08a User Manual
Page 58

26xx Technical Manual EN-V108
57
than the Flash high setting, the flash
will be handled as hang-up.
Secondary Ringing (FXS only)
Note: The feature will be enabled automatically when the Min. Digit
Count has been enabled and specified. It is used to have different ring
cadence when the incoming caller number is shorter than the setting of
“Min. Digit Count”
Ringing Frequency
Specify the Ringing frequency value.
ringing frequency : 15~100 (Unit : Hz)
Ringing ON
Specify the Ringing ON value.
ringing ring ON : 0~8000 (Unit : ms)
Ringing OFF
Specify the Ringing OFF value.
ringing ring OFF : 0~8000 (Unit : ms)
Ringing level
Specify the ringing level.
ringing level : 0 ~ 94 (Unit : V)
Min. Digit Count
Specify the minimum digit count
(1~10, 0: Disable), this feature is used
to change the ringing frequency by
detecting the digit length of incoming
calls’ number. When the digit length
of an incoming caller number is greater
than the specified setting, the system
will use primary ringing. If the digit is
less than the specified setting, the
system will use the secondary ringing.
Country
Specify the ringing standard to use.
1.
Press the “Apply” button (at the bottom) after you finish to save changes.
2.
Press the “Reboot” button to apply the changes.