Vuzix Wrap 920AR - Manual (Page 98)

• Wrap video eyewear set as Primary display.
Video is displayed in 2D only.
The eyewear’s being set for 2D display causes this or you are looking at an image that does not use a
compatible 3D format.
1. Double-press the Power Off & Toggle View Button on the Control Box. This resets the display to
the last user selected 2D/3D display mode.
2. Open the OSD and set the eyewear to display 3D video in Side-by-Side format.
3. If your video content does not support the popular side-by-side format, or one of the less
popular anaglyph formats there is not solution – it was not meant to be seen in 3D.
4. If you are using an application known to support side-by-side 3D, check the VR Manager
software to determine of an Extension is required for that application and if that Extension is
enabled. Each Extension is accompanied by Extension Notes to describe any special procedures
required to enable or configure that application.
Video Capture
Video is not being captured by one or both Wrap AR camera.
1. Run the “Amcap” application that was installed with the Wrap AR camera drivers. Using the
Devices menu, select one and then the other “Vimicro USB2.0 UVC PC Camera” listings. Both
should show the image currently being captured by that camera.
2. Video capture problems can also result from the use of a slower USB port, not USB 2.0 compliant
or a defective USB cable. Try another USB cable and a USB port known to be USB 2.0 compliant.
maxReality Viewer
Running the maxReality Viewer results in nothing more than a black screen.
You can exit out of the maxReality Viewer by pressing the “ESC” key.
A black screen can be caused by a lack of an active camera. Follow the steps indicated for a lack of
video capture to determine if both cameras are functioning correctly.
Head Tracking
The tracking function does not re-center correctly or drifts.
1. The Wrap Tracker does require re-calibration from time to time. Open the VR Manager software
and follow the calibration instructions provide earlier in this manual to re-calibrate your tracker.