beautypg.com

Operating instructions – Enviro Haven Direct Vent Fireplace User Manual

Page 8

background image

8

Operating Instructions

For Your Safety, Read Safety Precautions And

Lighting Instructions Before Operating

A) Make sure the pilot is lit.

B) Turn gas control knob COUNTER-CLOCKWISE

to ON.

C) Flip the burner switch to ON.

D) Turn HI/LO knob to the desired flame

height.

E) Turn on all electrical power to the unit.

NOTE: Check that all burner holes are lit.

TO TURN GAS FIREPLACE OFF:
Flip switch to OFF to turn off burners only.
If the fireplace is to be turned off for the season, or for servicing, turn the gas shut off valve to OFF. DO

NOT FORCE IT. If the unit is going to be serviced, turn off the electrical power to the unit as well.
NOTE: When the unit is turned on for the first time, it should be turned onto high, with the fan OFF,

for the first two to four hours. This will cure the paint, logs, gasket material, and other products used

in the manufacturing process. It is advised that a door or window be opened as the unit will start to

smoke, which can irritate some people. After the unit has gone through the first burn, turn the unit OFF,

including the pilot, and let the unit get completely cold. Then remove the glass and clean it with a good

gas fireplace glass cleaner, available at your local Enviro dealer. See M

AINTENANCE

A

ND

S

ERVICE

- G

LASS

D

OOR

R

EMOVAL

and M

AINTENANCE

A

ND

S

ERVICE

- C

LEANING

T

HE

G

LASS

..

R

EMOTE

CONTROLS

:

This fireplace can use an optional remote control or an optional cordless wall thermostat. If either of

these are to be used to control the fireplace for the majority of the time, leave the ON/OFF switch (on the

control panel) in the remote/thermostat position. Consult the instructions included with the remote/wall

thermostat for operation guidelines.

N

ORMAL

S

OUNDS

D

URING

O

PERATION

:

Table 1: Normal Sounds

Component

Sound & Reason

Haven & Fascia

Creaking when heating up or cooling down.

Burner

Light pop or poof when turned off; this is more common with LP units.

Temperature Sensor

Clinking when it senses to turn the blower on or off.

Pilot Flame

Quiet whisper while the pilot flame in on.

Blower / Fan

Air movement that increase and decreases with the speed of the blower.

The blower is pushing the heat from the fireplace into the room.

Gas Control Valve

Dull click when turning on or off, this is the valve opening and closing.

Figure 5. Control Panel

HI/LO Knob

Gas Control

Piezo Ignitor

Blower

Speed

Control

High

Low

Thermostat

Burner

Switch

On

Off

B

URNER

L

IGHTING

: