Enviro Haven Direct Vent Fireplace - Manual (Page 10)

10
Maintenance And Service
C
LEANING
D
ECORATIVE
S
URFACES
:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
finish, including cleaners, polish and finger prints. It is important to note that fingerprints and other
marks can leave a permanent stain on plated finishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the fireplace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
G
LASS
D
OOR
R
EMOVAL
:
In order to install the log set, and for regular
cleaning, the glass door must be removed.
There are two (2) door latch mechanisms
under and two (2) above the glass door
shown in Figure 6 & 7. Each latch has two
(2) finger grooves, use these to pull the
mechanisms straight out. When the latches
are unhooked, lift the door up and forward
off the unit.
To replace the glass door, simply reverse the
above procedure.
Warning: Do not touch or attempt to
remove the glass if the fireplace is not
completely cold.
WARNING: Never operate the fireplace
with the glass removed.
Figure 6. Bottom latches for glass, disengaged.
Figure 7. Top latches for glass door, engaged.
Figure 8. Wing Nut to Remove
the Burner.
1. Ensure the appliance is turned off and cool.
2. Remove the fascia, glass door (see M
AINTENANCE
A
ND
S
ERVICE
- G
LASS
D OOR R EMOVAL ), logset, embers and firebox liner.
3 Undo the wing nut under the right side of the burner (see Figure 8)
and remove the screw.
4. Lift the right end of the burner up, slide it to the left (off of the main
orifice), then up and out.
B
URNER
R
EMOVAL
: