Enviro Haven Direct Vent Fireplace - Manual (Page 32)

Figure 52. Charcoal Pieces Installation.
Figure 53. Ember Placement.
Secondary Installation
6. Install the two (2) grommets; place a 8-32 x 3⁄4” bolt
through each grommet then attach the bolt to the
back cover using a 1⁄4” socket (see Figure 51)
7. Ensure the wiring harness is attached to the fan
then hook the two (2) slots on the fan box over the
grommets installed in the last step.
8. Re-install the pilot shield, orifice and valve assembly.
9. Slide the snap switch in place under the holding tabs
above the SIT valve (see Figure 47).
10. Remove knob and nut from the fan controller. Place the dial stud through the fan hole in the control
board through the back to the front (see Figure 48). Tighten the nut on the front side to keep the
fan controls in place (see Figure 49), then install the knob onto the stud.
11. Use marrettes to connect the fan wiring harness wires to the house wiring.
12. Re-install the control panel.
L
OG
S
ET AND
E
MBER
I
NSTALLATION
:
Install the ceramic or steel liner (refer to “S
ECONDARY
I
NSTALLATION
- I
NSTALLATION OF
S
TEEL
F
IREBOX
L
INER
OR O PTIONAL C ERAMIC F IREBOX L INER ”) before installing the log set. A liner MUST be installed before the
unit can be turned on. The placement of the charcoal pieces, embers, and logs are not arbitrary. If they
are positioned incorrectly, the flames can be “pinched” and will not burn correctly. The burner comes with
six (6) locator pins (pointed out in Figure 52), which make alignment easier. The locator pins are long
Figure 51. Grommets to Hang Fan On.
enough to go through the charcoal and
be used to locate for the logs. Carefully
set the three (3) charcoal pieces (Figure
46) in place.
When the charcoal pieces are in place the
embers (Figure 53) can be placed onto
the burner to create a realistic look. A bag
of rock wool is provided. Spread the rock
wool in a sparse but even manner.
WARNINGS: DO NOT pack this ember
material as this could create an unsafe
condition. The pieces should be lightly
placed so they don’t block any of the
burner ports. DO NOT allow any of
the embers to rest against the pilot
assembly.
Caution: Use only the type of ember
material supplied with this fireplace. Due
to the irregular size of the ember material,
there may be more than required. Use of
other foreign materials on the burners
may create dangerous conditions.
32
NOTE: The charcoal pieces and logs are fragile and should be handled gently.