Enviro Haven Direct Vent Fireplace - Manual (Page 33)

33
Secondary Installation
Figure 54. Left & Right Logs Installation.
Figure 56. Haven complete log set-up with embers burning.
Maintenance: Once a year, the charcoal pieces and logs should be removed and checked for deterioration
or large amounts of soot. A small amount on the bottom side of the logs is normal. Remove and replace
the logs in the same manner described above.
If new/more embers and rock wool are required, contact your nearest ENVIRO dealer.
Never operate the fireplace with the glass door removed.
Each log sits on two (2) locator
pins and may lean against the
liner walls (see Figures 54 &
55).
Figure 56 shows The Haven
burning with a good flame.
NOTE: While the glass is still
removed, it is recommended that
the gas line be purged by lighting
the pilot.
When lighting the fireplace for
the first time since the log set
and embers have been installed/
replaced, watch for ignition
at ALL the burner ports. If a
long delay is noticed, turn the
appliance off and wait for it to
cool down. Then remove the
glass and rearrange the ember
material, making sure none of
the burner ports are blocked.
Figure 55. Centre Log Installation.