Verilink QPRI 2921 (880-503143-001) Product Manual User Manual
Page 72
Configuring the QPRI 2921 Via the NCM 2000 Craft Interface
3-38
Verilink QPRI 2921
DP
Destination Port—Displays the Node “Map” and prompts for the DEST Port
shelf, slot. Use this option to designate the ending point of the circuit.
Once the Shelf and slot position of the Source Port has been entered, you
are prompted with 4 choices.
1) net1
2) net2
3) net3
4) net4
SM
SRC Port Chn—Source Timeslot. Designate which T1 timeslots you wish to
use in this circuit.
Note: In ISDN, timeslot 24 is normally reserved for use in D-channel call
set-up. For this reason, avoid building circuits which use timeslot 24.
For ISDN, a call-reference option is provided to designate the call profile
for backup.
1—24 or press
ENTER
to exit
DM
DST Port Chn—Destination Timeslot Designate which T1 timeslots you
wish to use at the Destination Port.
Note: In ISDN, timeslot 24 is normally reserved for use in D-channel call
set-up. For this reason, avoid building circuits which use timeslot 24.
For ISDN, a call-reference option is provided to designate the call profile
for backup.
1—24 or press
ENTER to exit
U
Bus—Select a backplane bus for intermodule communication. The A Bus is
always used for ISDN.
1) A
2) B
3) C
4) Auto
A
Primary circ—Primary Circuit Name
12 characters
maximum
SE
src err mask—Backup when SRC port set:
1) ais
2) yel
3) los
4) lof
5) uas/ses
C
dst call ref—Dial-out profile
DE
dst err mask—Backup when DST port set:
1) ais
2) yel
3) los
4) lof
5) uas/ses
O
dbkp timeout—Backup circuit timeout
Day (max 5
days) Hour (max
23 hrs)
Min (max 59
min)
G
err clr mask—Switch back when clear
1) ais
2) yel
3) los
4) lof
5) uas/ses
S
Setup—This option MUST be selected to set the new configurations. If this
option is not selected, the card reverts to the previous configuration.
X
Exit—exits this menu and displays the Circuit Manager Menu, Figure 3-25,
Command
Description
Options