Verilink PRISM 3111 (34-00242) Product Manual - Manual (Page 88)

80 A PPENDIX A: SNMP A GENT
testing(3) - returned for the DS1 interface, Port 1 or Port 2 if the interface has
a test loop or BERT active.
ifLastChange: (read-only)
GET: returns the time in hundredths of a second since the interface was
changed, or reset.
RFC 1406 -
DS1/E1 MIB This RFC was published in January 1993. It is meant to be a replacement for RFC
1232. RFC 1406 is used to manage DS1 interfaces, and in our case specifically a
T1 interface. The following is a list of the objects contained within this RFC, and
the manner in which the unit responds to each.
dsx1ConfigTable dsx1LineIndex: (read-only)
GET:
(2) - if a NIC is not installed
(3) - if a NIC is installed
dsx1IfIndex: (read-only)
GET:
(2) - if a NIC is not installed
(3) - if a NIC is installed
dsx1LineType: (read-write)
GET:
dsx1ESF(2) - the Network Framing is set to ESF
dsx1D4(3) - the Network Framing is set to D4
SET:
dsx1ESF(2) - sets the Network Framing to ESF
dsx1D4(3) - sets the Network Framing to D4
dsx1LineCoding: (read-write)
GET:
dsx1B8ZS(2) - the Network Coding is set to B8ZS
dsx1AMI(5) - the Network Coding is set to AMI
SET:
dsx1B8ZS(2) - sets the Network Coding to B8ZS
dsx1AMI(5) - sets the Network Coding to AMI
dsx1SendCode: (read-write)
GET:
dsx1SendNoCode(1) - the unit is not in a Bert Test and not sending a PLB or
LLB loopup/loopdown request to the Far End