Verilink PRISM 3111 (34-00242) Product Manual - Manual (Page 66)

58 C HAPTER 4: T ERMINAL I NTERFACE
Reset Errors Pressing with the cursor on this field causes the test error results to be
cleared to zero.
T1 NET/DTE Status These two fields display the fault status of the network and the far end DTE. They
indicate current fault conditions. They do not indicate that alarm thresholds are
exceeded. Status indications are described in NET /DTE Status: These two fields
display the fault status of the network and the T1 DTE. They indicate current fault
conditions. They do not indicate that alarm thresholds are exceeded. Status
indications are described in Table 4-5.
Near Loops Displays the loop status of the near element.
Far Loops Displays the loop status of the far element.
Configuration The Configuration screens allow you to view and set configuration parameters for
the network elements. To save your changes in a configuration screen, press the
key.
The underlined values are the factory default parameters.
Figure 4-8 Configuration Menu
Line Parameters The Line Parameters screen (Figure 4-9) allows you to review and set line
parameters for the selected element on the T1 circuit. To send the new line
configuration to the unit, press on one of the fields, change the Element
selection, or exit the screen.
Table 4-5 Status Indications
Status Description
OK
No errors are currently detected.
ERR Frame bit errors, CRC errors, or BPVs are detected.
LOS A loss of signal condition exists.
OOF An out of frame condition exists.
RAI Far end is receiving a remote alarm indication signal.
AIS The far end is receiving an alarm indication signal.
UAS An unavailable signal state exists due to consecutive severely errored seconds.
Port
Parameters
page 62
Alarm
Parameters
page 61
TCP/IP
Parameters
page 68
Configuration Menu
Management
Parameters
page 70
DBU
Parameters
page 65
Summary
page 73
SNMP
Parameters
page 69
Line
Parameters
page 58