Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 75)

NetEngine IAD User Guide
WAN Configuration 56
Using the
WAN
Config-
uration
Menu
Configuring the IAD for data involves several tasks. Tasks in this chapter
are described beginning at the WAN Configuration menu (which varies,
based on the WAN interface and datalink protocol).
Figure 4–3. WAN Configuration Menu
Selecting
the
Datalink
Protocol
If you are setting up voice and data channels, you can select ATM or
Frame Relay as you set up the channels, in the section Setting Up TDM
Voice, following.
To select ATM or Frame Relay as the datalink protocol:
1. On the WAN Configuration menu, type 1 to select Configure Datalink
Protocol.
2. The IAD displays the WAN Datalink Protocol Configuration menu,
identifying the current datalink protocol just below the banner.
Figure 4–4. WAN Datalink Protocol Configuration Menu
**************************************
WAN Configuration Menu
**************************************
Configuring T1/E1
1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure DLCIs
4. Configure FR Options
The IAD displays
the physical
interface in this
status message.
These options change,
based on your choice
of datalink protocol
NOTE You must sign on as Supervisor to configure the WAN
interface.
Be sure to reset the IAD when you are done making changes
to WAN settings. Resetting the IAD causes the configuration
changes to take effect.
*********************************************
WAN Datalink Protocol Configuration Menu
*********************************************
Current DataLink Protocol: Frame Relay
6. ATM
7. Frame Relay
E. TDM Voice
This option applies only to IADs
with channelized T1 WAN ports.
LAN LINK LAN ACT WAN LINK VOICE POWER
6100
6500 6100 or 6500 series IADs do not support Frame Relay.