Displaying the iad state, Configuring trace settings, Selecting insufficient bandwidth sound – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 178
NetEngine IAD User Guide
Voice Path Configuration
159
Configuring the Ring Test
Type
C
to configure the ring test.
1. The IAD displays the port prompt:
Port to enable.
Type the port number and press Enter.
2. The IAD displays the on hook timing prompt:
Number of seconds for port to stay on hook.
Type the value in seconds and press Enter.
3. The IAD displays the off hook timing prompt:
Number of seconds for port to stay off hook.
Type the value in seconds and press Enter.
Displaying Ring Test Parameters
Type
D
to display the current ring test parameters.
The IAD displays the following information:
port = 2, onhooktime = 5, offhooktime = 8S.
Starting and Stopping the Ring Test
Type
S
to start the ring test.
The IAD displays the menu and begins the ring test on the specified port.
The ring test continues until you stop the test by pressing option
T
.
Displaying the IAD State
Type
S
to display the on hook state for each port.
The IAD displays the following information:
Attempting to Connect to CPX, counter = 0
Port 01 is offhook Call Control state = Idle POTS state = Disabled
Port 02 is offhook Call Control state = Idle POTS state = Disabled
Port 03 is offhook Call Control state = Idle POTS state = Disabled
Port 04 is offhook Call Control state = Idle POTS state = Disabled
Port 05 is offhook Call Control state = Idle POTS state = Disabled
Port 06 is offhook Call Control state = Idle POTS state = Disabled
Port 07 is offhook Call Control state = Idle POTS state = Disabled
Port 08 is offhook Call Control state = Idle POTS state = Disabled
Received Segmentation Layer CRC failures since powerup = 0
Configuring Trace Settings
These commands are reserved for use by JetStream or Verilink network
engineers.
Selecting Insufficient Bandwidth Sound
Type
V t
o select the type of dial tone heard by the telephone user if there
is insufficient WAN bandwidth to complete a call. The IAD displays the
Insufficient Bandwidth Indication Setting menu and the current setting: