Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 204)

NetEngine IAD User Guide
Multicast Configuration 185
Removing
a Multicast
Routing
Source
Type R to remove a Multicast Routing Source:
1. The IAD displays the IP address prompt:
Enter IP address for the Source:
Type the source IP address and press Enter.
2. The IAD displays the current subnet mask and prompt:
Enter subnet mask for the source:
(255.255.255.0) ->
Type the new subnet address and press Enter.
3. The IAD displays the available interfaces and a prompt:
Available Interfaces:
1. G2237 xDSL
2. 10/100BaseT Ethernet
0. (Abort)
Selection:
Type the option number to select the interface.
4. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to delete and press Enter.
5. The IAD The IAD permanently removes the multicast routing source
from the Multicast Routing Source Table and displays the Multicast
Configuration menu.
6. Reset the IAD (page 15 ) for changes to take effect.
Displaying
the
Multicast
Routing
Source
Type S to display the Multicast Routing Source. The IAD displays the
Multicast Routing Source Table.
NETWORK ADDRESS NETMASK INCOMING INTERFACE
*************** *************** ******************
0.0.0.0 0.0.0.0 0.0.0.0 190.232.5.1 default
Press any key to continue.