Basic voice path setup tasks, Voice path configur- ation menu, Figure 7–1. voice configuration menu – Verilink Net Engine (3150-30626-001) Product Manual User Manual
Page 159: Voice path configuration menu
NetEngine IAD User Guide
Voice Path Configuration
140
Basic Voice
Path Setup
Tasks
To configure voice path settings, you should complete the following tasks:
u
Select a voice gateway (page
u
Set the jitter delay (page
)
u
Set start mode (page
u
Set Compander mode (page
u
Set echo cancellation (page
u
Set loop gain (page
)
u
Set bandwidth tone (page
)
Voice Path
Configur-
ation Menu
Configuring the voice path settings involves several tasks. These are all
displayed and accessed on the Voice Configuration menu (displayed by
typing
P
on the Main menu).
Tasks in this chapter are described beginning at the Voice Configuration
menu.
Figure 7–1. Voice Configuration Menu
*******************************************
Voice Configuration
*******************************************
V. Set Voice Gateway
J. Set Jitter Delay
D. Display Jitter Delay
S. Set Start Mode (Loop Start/Ground Start)
T. Set SLIC Control Mode
U. Set Compander Mode (u-Law, A-Law)
O. Set On Hook Transmission Mode of Ground Start Lines
L. Set Idle Voltage Mode of Loop Start Lines
M. Set Debug Mode
E. Configure Echo Cancellation Default Settings
G. Set Loop Gain
C. Set Country Mode
NOTE
You must sign on as Supervisor to configure voice path
settings.
Be sure to reset the IAD when you are done making changes
to the voice path settings. Resetting the IAD causes the
configuration changes to take effect.