Verilink PRISM 3001 (34-00186) Product Manual - Manual (Page 9)

FCC Requirements 1-5
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference. The user will be required to correct the interference at his own expense.
Shielded cables must be used with this unit to ensure compliance with the Class A
FCC limits.
Notice to Users of 1.544 Mbps Service: The following instructions are provided
to ensure compliance with FCC Rules, Part 68:
1 All direct connections to T1 lines must be made using standard plugs and jacks.
2 Before connecting your unit, you must inform the local telephone company of the
following information:
Port ID: P /N/12 - 00635
REN /SOC (Service Order Code): 6.0 N
FIC (Facility Interface Code): 04DU9-BN
04DU9-DN
04DU9-IKN
04DU9-ISN
USOC jack: RJ-48C
3 If the unit appears to be malfunctioning, it should be disconnected from the
telephone lines until you learn whether the source of trouble is your equipment or
the telephone line. If your equipment needs repair, it should not be reconnected
until it is repaired.
4 The unit has been designed to prevent harm to the T1 network. If the telephone
company finds that the equipment is exceeding tolerable parameters, they can
temporarily disconnect service. In this case, the telephone company will give you
advance notice, if possible.
5 Under FCC rules, no customer is authorized to repair this equipment. This
restriction applies regardless of whether the equipment is in or out of warranty.
6 If the telephone company alters their equipment in a manner that will affect the use
of this device, they must give you advance warning so that you can have the
opportunity for uninterrupted service. You will be advised of your right to file a
complaint with the FCC.
7 The attached affidavit must be completed by the installer.
8 In the event of equipment malfunction, all repairs should be performed by our
company or an authorized agent. It is the responsibility of users requiring service
to report the need for service to our company or to one of our authorized agents.