Verilink AS4000 (34-00244) Product Manual - Manual (Page 34)

Quick Set-Up Guide
2-14 Verilink AS4000 User Manual
Build Connections 27. On the Connection Maps Manager Menu, select Active Map.
The current map configuration is displayed. Initially there are
no entries because no connections (circuits) have been built.
28. Press "A" to begin the process of adding a connection to the
map. The cursor appears over the Connection Name field,
which is currently blank. Press E
NTER to begin the process of
editing the connection name. Type "First T1" and press E
NTER
again to finish entering the name.
29. Leave the type set at Full Duplex, for the Source Slot select 01,
the location of the DS-3 module. Proceed to the Source Port
selection. A DS-3 module only has one network port. In the
case of a DS-3 module, the Source Slot option refers to the
particular T1 of the 28 T1s which a T3 contains. Select 01.
30. The Starting Source Timeslot option selects the first DS0
within the specified DS1 to be used for this connection. Leave
it at 01. Proceed to the Destination Slot selection field. Select
the Quad DS-1 module in slot 5. Select the first of the four T1
ports in that module for the Destination Port. Leave the
starting destination timeslot set for 01.
31. Proceed to selecting the speed for this connection. Scroll
through the list of selectable speeds until 1.536 Mbit/s and 24
DS0s are selected. Set the voice data selection to Voice. Save
using "S" and exit this menu. The first connection now appears
in the summary on the Map Configuration Menu.
Figure 2-18 Example Connection