Verilink APS 2000 T1 Line Protection (880-502411-001) Product Manual - Manual (Page 50)

Configuration
3-22 Verilink APS 2000 User Manual
4. Select flashbank A.
5. When the pSH+> pSH+> pSH+> pSH+> prompt returns type “FTP
server>”.
6. Login to the FTP server using the method required by your FTP
server program.
7. Use the “CD” command to change to the directory where you
previously placed the file FLASH.B.
8. Use “DIR” or “ls -l”, as appropriate, to produce a long display of
the files in this directory.
9. Record the file size of the FLASH.B file.
10. Issue the command “binary”.
NOTE: If you fail to issue the command “binary”, the file will be
corrupted when it is transferred.
11. Issue the command “get flash.b flash.hex”.
The file is now transferred from the FTP server to a RAM disk in the
SCC card. If you are using Ethernet, this process will take about a
minute, more or less, depending on LAN segment traffic. If using
FTP over SLIP instead of Ethernet, it may require 15 to 30 minutes
to transfer the file.
12. End the FTP session by typing “quit” and you will be returned
to the pSH+> pSH+> pSH+> pSH+> prompt in the SCC 2120.
13. Confirm that the transfer was successful by issuing the
command “ls -l” and comparing the size of FLASH.HEX to
FLASH.B as recorded in step 9. If the file sizes do not match,
DO NOT PROCEED, instead type “rm flash.hex” to remove the
incorrect size file and return to step 5.
14. If the file sizes match in step 13, type “craft” and login to the
Craft interface.
15. Select the Node Administration Menu by typing “O”.
16. Select flash download by typing “F”.
17. Select flashbank B.
18. Once the flash download is complete, use the “B” command to
boot. Boot from flashbank B. Login to the craft interface of
the SCC and verify that the version of firmware being
executed, as shown on the top line of the Main Menu, is the
version you just installed.