Verilink APS 2000 T1 Line Protection (880-502411-001) Product Manual User Manual
Page 4

iv
Verilink APS 2000 User Manual
cuito de vuelta por tierra permanente.
CIRCUITOS A INTERCONECTARSE
Circuitos que se interconectan a la red de telecomunicaciones deben hacerse de
tal manera que cumplan con los requisitos estipulados en las especificaciones
“EN60950:1992/A2:1933, Sección 6.2, para los voltages de circuitos
interconnectados a la Red de Telecomunicaciones (TNV),” despues de terminar
las connecciones entre los circuitos.
Deutsch
VORSICHT!
Explosionsgefahr bei unsachgemäßem Ersetzen der Batterie! Batterie gleichen
Typs und gleicher Qualität benutzen, wie vom Hersteller empfohlen. Entsorgung
der Batterie nach Anweisung des Herstellers!
VORSICHT, GEFAHR!
Um keinen Schlag zu erhalten beim Versagen der electrischen Anlage, muss der
Stromanschluss von einem Elektriker vorgenommen werden. Der elektrische
Pol, versehen mit dem Erdsymbol (
) muss am Stromanschluss permanent
geerdet sein.
VORSICHT!
Schaltungen, die in den Geräten zusammengeschaltet sind, müssen weiterhin
den Vorschriften EN60950:1992/A2:1933, Absatz 6.2 für Telecommunications
Netz Spannung (TNV) Schaltkreize entsprechen.
Canadian
Requirements
This digital apparatus does not exceed the Class A limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques (de la class A) prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
The Industry Canada label indentifies CS-03 certified equipment. This certification
means that the equipment meets certain telecommunications network protective,
operational and safety requirements. Industry Canada does not guarantee the
equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company’s inside wiring associated with a single line individual service may be
extended by means of a certified connector assembly (telephone extension cord).
The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections
of the power utility, telephone lines and internal metallic water pipe system, if
present, are connected together. This precaution may be particularly important in
rural areas.
Caution: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
Safety Precautions
This equipment is intended to be installed only in a Restricted Access Location that
meets the following criteria:
• Access can only be gained by service personnel or users who have been
instructed about the reasons for the restrictions applied to the location and
about any precautions that must be taken.