Figure 3-1, Table 3-3 – Verilink APS 2000 T1 Line Protection (880-502411-001) Product Manual User Manual
Page 32

Configuration
3-4
Verilink APS 2000 User Manual
Figure 3-1 Node Administration Menu
If any changes are made to the Ethernet or SLIP configurations,
those changes do not take effect until the module is rebooted.
Rebooting an SCC 2120 by using the boot command has no effect
on user data passing through the SCC 2120 module.
NOTE: The SLIP IP address and the Ethernet IP address must reflect
different network segments in terms of the subnet masks in
use. If the SLIP and Ethernet addresses are set to reflect the
same network segment an error message “Sendto: new socket
failed” will repeat constantly until the error is corrected and
the SCC 2120 is rebooted.
Table 3-3
Node Administration Commands
--- NODE CONTROLLER MENU ---
--- NODE CONTROLLER MENU ---
--- NODE CONTROLLER MENU ---
--- NODE CONTROLLER MENU ---
T) time
T) time
T) time
T) time
D) date
D) date
D) date
D) date
I) node id
I) node id
I) node id
I) node id
N) site name
N) site name
N) site name
N) site name
A) Slip Configuration
A) Slip Configuration
A) Slip Configuration
A) Slip Configuration
E) Ethernet Configuration
E) Ethernet Configuration
E) Ethernet Configuration
E) Ethernet Configuration
M) Modem Configuration
M) Modem Configuration
M) Modem Configuration
M) Modem Configuration
O) IP Gateway
O) IP Gateway
O) IP Gateway
O) IP Gateway
H) trap host ip address
H) trap host ip address
H) trap host ip address
H) trap host ip address
C) community string (read)
C) community string (read)
C) community string (read)
C) community string (read)
W) community string (write)
W) community string (write)
W) community string (write)
W) community string (write)
F) flash download
F) flash download
F) flash download
F) flash download
B) boot
B) boot
B) boot
B) boot
R) reset com ports
R) reset com ports
R) reset com ports
R) reset com ports
S) node controller status
S) node controller status
S) node controller status
S) node controller status
P) set privileged password
P) set privileged password
P) set privileged password
P) set privileged password
U) set unprivileged password
U) set unprivileged password
U) set unprivileged password
U) set unprivileged password
Y) element download
Y) element download
Y) element download
Y) element download
X) exit menu
X) exit menu
X) exit menu
X) exit menu
[1,1] NEAR TAC 2110 >
[1,1] NEAR TAC 2110 >
[1,1] NEAR TAC 2110 >
[1,1] NEAR TAC 2110 >
Menu Option
Description
Instructions
T) time
Sets the time of
day.
Enter new time (hh:mm:ss): — use the format shown.
D) date
Sets the date.
Enter new date (mm-dd-yy): — use format shown.
I) node id
Sets a numeric
identifier.
Maximum field length = ten digits, distinguishes one node
from another, each node in a network must have a unique
node id.